Rev: 10.23.23 Page 17 CCD-0005481
7. During the, "Retract Jacks" (Fig. 23C), or in "Manual Mode", (Fig. 24B), Figure 28, "Jacks Are Retracting"
screen is displayed.
8. Figure 29, "Parking Brake Error", will appear when no parking brake signal is received and there is no
pressure switch signal indicating jacks are still retracted. The screen is prompted before auto level and
manual mode functions. The screen is prompted for five seconds, then returns to home screen (Fig.
23).
If jacks are extended and parking brake signal is lost, jacks will automatically retract.
9. Figure 30, "Insufficient Voltage", screen may be prompted before or during “Auto Level”,
“Retract Jacks” or “Manual Mode” functions. This screen is prompted when the control is receiving
less than 10.5 volts for auto level function 7.5 volts.
Fig. 29
Parking Brake Error
Fig. 30
Insufficient Voltage
To Next Page
Loading...