Warning
Install, use and maintain this equipment according to Liquid Controls Group’s instructions and all applicable federal,
state, local laws and codes. Periodic inspection and maintenance is essential.
Liquid Controls Group One Year Limited Warranty
Liquid Controls Group warrants that its products will be free from defects in material and workmanship for a period of
one year from date of installation, provided that the warranty shall not extend beyond twenty-four (24) months from the
date of shipment from Liquid Controls Group. If a warranty dispute occurs, the distributor may be required to provide
Liquid Controls Group with proof of date of sale. The minimum requirement would be a copy of the distributor’s invoice
to the customer. Liquid Controls Group products which fail within the warranty period due to defects in material or
workmanship will be repaired or replaced at Liquid Controls Group’s option, when returned, freight prepaid to Corken,
Inc., 3805 N.W. 36th Street, Oklahoma City, OK. 73112.
Parts subject to wear or abuse, such as mechanical seals, vanes, piston rings, packing and other parts showing
signs of abuse are not covered by this limited warranty. Also, equipment, parts and accessories not manufactured by
Liquid Controls Group but furnished with Liquid Controls Group products are not covered by this limited warranty and
purchaser must look to the original manufacturer’s warranty, if any. This limited warranty is void if the Liquid Controls
Group product has been altered or repaired without the consent of Liquid Controls Group.
All implied warranties, including any implied warranty of merchantability or fitness for a particular purpose, are expressly
negated to the extent permitted by law and shall in no event extend beyond the expressed warranty period.
Liquid Controls Group disclaims any liability for consequential damages due to breach of any written or implied warranty
on Liquid Controls Group products. Transfer of toxic, dangerous, flammable or explosive substances using Liquid
Controls Group products is at the user’s risk. Such substances should be handled by experienced, trained personnel
in compliance with governmental and industrial safety standards.
Important notes relating to the European Union (EU) Machinery Directive
Pumps delivered without electric motors are not considered as machines in the EU Machinery Directive. These pumps
will be delivered with a Declaration of Incorporation. The fabricator of the machinery must assure and declare full
compliance with this Directive before the machine in which the pump will be incorporated, or of which it is a part, is
put into service.
Contacting the Factory
Before you contact the factory, note the model number and serial number of your pump. The serial number directs
us to a file containing all information on material specifications and test data applying to your specific pump.
When ordering parts, the Liquid Controls Group Installation, Operation and Maintenance (IOM) manual should be
consulted for the proper part numbers. ALWAYS INCLUDE THE MODEL NUMBER AND SERIAL NUMBER WHEN
ORDERING PARTS.
The model and serial numbers are shown on the nameplate of the unit. Record this information for future reference.
Model no.
Serial no.
Date purchased
Date installed
Purchased from
Installed by
2
To Next Page
Loading...
Need help?
General