LiteOn LVW-5045 - Connecting a Decoder

11
CONNECTING A DECODER (IF REQUIRED)
Connecting a decoder
Connect the CANAL+ Decoder to the unit and the TV set
as shown:
1. Use a RF antenna cable to connect the RF IN jack on
the unit to the antenna outlet. ( )
Use a RF antenna cable to connect the RF OUT jack on
the unit to the RF IN jack on the television.( )
2. Use a SCART cable (not supplied) to connect the
SCART IN jack on the unit to the SCART OUT jack on the
CANAL+ Decoder. ( )
Use a SCART cable to connect the SCART OUT jack on
the unit to the SCART IN jack on the television. ( )
Notes:
Enter Channel Editor menu to set decoder on for the desired channels. (refer to the section titled “Channel Editor”)