13
TV CHANNEL SETUP
9. The channel scanning starts. This process may
take a few minutes.
10.When all the TV channels have been searched
and stored, press [SETUP] to exit.
Note:
If the available channel number in your residence area exceeds
the maximum receivable channel numbers of this DVD
Recorder, the scan will be discontinued. The maximum
receivable channel numbers are:
Antenna: 168 (chs)
Cable: 104 (chs)
Auto: 176 (chs)
Fine-tuning TV channels manually
After you have performed the channel scanning, you may like to
fine-tune the TV channel signal manually. Follow the steps
below to complete fine tune.
1. Press [SETUP] to display the “setup menu,” press
[p] [q] to select the “TV TUNER” icon and
press [u].
2. Press [p] [q] to select “FINE TUNE” and press
[u].
3. Press [p] [q] to fine-tune the channel signal.
4. When complete, press [SETUP] to exit the
setup menu.
Editing TV channels manually
After you have performed channel scanning, you may like to
further edit the TV channels. This function allows manually
adding/deleting channels, swapping channel order, inserting a
channel to a specific order, renaming the channels and so on.
1. Press [SETUP] to display the “setup menu,” press
[p] or [q] to select the “TV TUNER” icon and
press [u].
2. Press [p] [q] to select “Utility” and press [u].
3. Press [p] [q] to select “edit channel” and press
[u]. The channel editor menu will be displayed.
For detailed operation instructions on the “channel editor” menu,
refer to the “Channel Editor” section.
TV Channel Scanning
When the “scan channel” function is activated, the TV channels
are searched and stored in a specific order. If the channel
assignment of your TV content provider is changed or if you are
reinstalling this DVD recorder, you may need to start this
procedure again. This will replace the TV channel stored with the
new ones.
Before scanning channel, set the “TV signal” and “country” for
initiation.
1. Ensure the antennas are securely connected to
the DVD recorder.
2. Switch on the TV set and the DVD recorder.
3. Press [SETUP] to display the setup menu, press
[p] [q] to select the “TV TUNER” icon and
press [u].
4. Press [p] [q] to select “TV signal” and press
[u].
5. Press [p] [q] to select “cable,” “antenna” or
“auto” depending on how you receive your
terrestrial TV channels and press [ENTER]. Press
[t] to return to the previous menu and save the
setting.
If you select “auto,” the unit will automatically scan both
channels available at cable and antenna connections, which
might take longer than needed.
6. Press [p] [q] to select “Country” and press
[u]. Press [p] [q] and [ENTER] to select the
country of your residence from the list . Press [t]
to return to the previous menu and save the
setting.
7. Press [p] [q] to select “Utilities” and press [u].
8. Press [p] [q] to select “scan channel” and
press [ENTER] to start channel scanning.
If you wish to stop scanning, move to “stop scan” and press
[ENTER]. The scanning process will be discontinued.
To Next Page
Loading...
