To Next PageTo Next Page
Need help?Do you have a question about the Livezi Z-Plus and is the answer not in the manual?
General| Brand | Livezi |
|---|---|
| Model | Z-Plus |
| Category | Air Conditioner |
| Language | English |
Details on wiring compliance, power supply requirements, and ensuring secure connections.
Explains the Z-Plus system's central control, modes, and unique airflow management.
Overview of Z-Plus's capacity adjustment and airflow modulation.
The MPM unit supports up to eight zones and has two touchpad ports.
Utilizes hard and soft buttons for system and zone control.
Allows connecting multiple touchpads via expansion modules.
Central connection point for AC, dampers, touchpads; factory settings and sensor options.
Details the effects of DIP switch settings on system performance and functionality.
Specifies requirements for motorised barrel dampers.
Information on wiring connectors, cable separation, length, and recommended cabling.
Checks for secure connections, correct phase, fuse rating, termination, and power supply.
Verifies free airflow, condenser fan operation, and secure cabinet panels.
Checks unit inclination, condensate lines, ductwork, and anti-vibration mounting.
Verifies no leaks, insulation, proper support, and absence of kinks/dents.
Checks for leaks, secure joints, clean filters, and open outlets.
Ensures correct mounting, power connection, touchpad/motor connections, and unit interconnect cable.
Enables additional features via the 8-way DIP switch at the Z-Plus MPM.
Describes the startup routine for dampers and checking main modules for fault LEDs.
Outlines steps for correct operation, safety mechanisms, and configuration of zones, motor time, capacity, favorites, touch, and service timer.
Adjusts display to show only present zones by using +/- keys.
Sets motor drive time for damper motors based on type (Livezi or Belimo).
Adjusts peak system capacity to match peak load or area used in calculation.
Groups zones for simultaneous control and includes time clock programs.
Recalibrates the touchscreen display if necessary, requiring stylus use.
Logs indoor fan runtime for programmed maintenance and warranty conditions.
Sets Min, Max, and Room Size parameters for each zone's damper position.
Verifies damper operation at off, 100%, and 50% open positions.
Allows renaming of zones using the touchscreen interface.
Addresses selecting the appropriate port for Z-Plus Touch connection.
Explains the two operating modes: Damper Control and Unit Control.
Describes how to toggle zone status (ON/OFF) using hardware buttons.
Guides on adjusting target zone position (airflow) using Up/Down soft keys.
Details how to toggle the unit's ON/OFF state via the soft key.
Explains changing modes (Vent, Cool, Heat, Auto) via the soft key.
Describes how to cycle fan speeds (High, Medium, Low, Auto) via the soft key.
Guides on using +/- soft keys to adjust the desired target temperature.
Explains setting active days, start, and finish times for the system timer.
Guides on entering the Real Time Clock screen to set time and date.
Describes how to disable time-based ON/OFF events for holidays.
Illustrates the connection layout for dampers, motor outputs, and the central unit.
Lists fault codes and messages for digital inverter systems to aid troubleshooting.
Lists fault codes and messages for dual inverter systems to aid troubleshooting.
