• Please use the smart meter cable in the accessory box for communication.
Wiring Connection Procedure
Step1: Assembling the BMS cable Connector
1. Make LAN cable with RJ45 terminal.
2. Thread the swivel nut over the LAN cable.
3. Press the cable support sleeve out of the cable gland.
4. Remove the filler plug from the cable support sleeve.
5. Route the LAN cable through an opening in the cable support sleeve.
6. Thread the LAN cable through the cable gland.
Step2: Insert the RJ45 plug of the network cable into the pin connector on the inverter
until it snaps into place.
Meter Connector Pin Definition
To Next Page
Loading...
