Operating manual and inspection booklet
Camping
148 3532085
Cooking
Fig. 143: Combination cooking hob
(example)
Fig. 144: Settings of the operating
elements:
OFF, High flame, Low flame
The gas cooker is located underneath a safety glass plate.
1. Lift the glass plate. The separate glass plate of the sink can
remain closed.
2. Open the gas bottle valve and open the “Hob” quick-action
valve.
3. Press the switch button and turn it anticlockwise to the
highest position (high flame)
4. Press the button further and hold a burning match or
barbecue lighter against the burner. In models with
automatic ignition, the procedure is similar, except for the
automatic ignition when the button is pressed. In models
with manual ignition, the procedure is similar, except that
you must press the ignition button on the front plate to ignite
the burner.
5. After ignition, keep the button pressed for another 10 to 15
seconds.
6. Release the button and use the regulator to adjust the gas
flame to the required level. Do not push the regulator when
adjusting.
7. If the burner does not ignite within 15 seconds, release the
button and wait for at least one minute before you repeat
steps (3) to (6).
8. To shut down, turn the button until the line on the button is
aligned with the dot at the control panel.
NOTE
After the flame extinguishes, the safety pilot valve
automatically blocks the gas supply.
9. Close the "Cooker" quick-action valve and the gas bottle
valve.
10. Wait until the hob has cooled down, clean, and cover with
the glass plate.
To Next Page
Loading...