FIG. 1 Front View
Installation and service must be performed by a qualified
service installer, service agency or the gas supplier.
Factory warranty (shipped with unit) does not apply to units
improperly installed or improperly operated.
Experience has shown that improper installation or system
design, rather than faulty equipment, is the cause of most
operating problems.
1. Excessive water hardness causing a lime/scale build-up in
the copper tube is not the fault of the equipment and is not
covered under the manufacturer's warranty (see Water
Treatment and Water Chemistry).
2. Excessive pitting and erosion on the inside of the copper
tube may be caused by too much water velocity through the
tubes and is not covered by the manufacturer's warranty
(see Boiler Flow Rates and Temperature Rise for flow
requirements).
This manual supplies information for the installation, operation
and servicing of the appliance. It is strongly recommended that
this manual be reviewed completely before proceeding with an
installation.
Upon receiving equipment, check for signs of shipping
damage. Pay particular attention to parts accompanying the
boiler, which may show signs of being hit or otherwise being
mishandled. Verify total number of pieces shown on packing
slip with those actually received. In case there is damage or a
shortage, immediately notify carrier.
DO NOT USE THIS APPLIANCE IF ANY PART
HAS BEEN UNDER WATER. THE POSSIBLE
DAMAGE TO A FLOODED APPLIANCE CAN
BE EXTENSIVE AND PRESENT NUMEROUS
SAFETY HAZARDS. ANY APPLIANCE THAT
HAS BEEN UNDER WATER MUST BE
REPLACED.
DO NOT:
CHECKING EQUIPMENT
IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR MAINTENANCE can
cause injury or property damage. Refer to this manual.
For assistance or additional information, consult a
qualified installer, service agency or the gas supplier.
WARNING
Retain this manual for future reference.
NOTE:
SPECIAL INSTRUCTIONS
TO OWNER
WARRANTY
INSTALLATION AND SERVICE MANUAL
Power-Fin
®
HOT WATER HEATING BOILERS
DOMESTIC WATER HEATERS
500,000, 750,000, 1,000,000 and 1,300,000 Btu/hr MODELS
PB-PF-i&s-03
To Next Page
Need help?
General