SECTION 2.67
Lockly Access Touch Pro will notify you with a continuous beep that it's time to
change
the batteries before they reach critical level. You should replace the
batteries
immediately to avoid the lock from shutting down and auto locking.
If you do not change the batteries after hearing the low battery warning alert
beeps, the alert will eventually stop. You will then have 3 chances to unlock using
your fingerprint. If unlocking was successful, the low battery warning alert will
come back on for one minute. The lock will then auto-lock (within 5 seconds)
and return to low battery mode.
Dead Battery
Condition Indicator Solution
Low Battery
Low battery warning
alert (continuous beep).
Replace batteries immediately to
avoid battery failure. Lock may
still operate for a short period (up
to 300 cycles) in low battery condition.
When there is no alarm
sound(continuousbeep)
and fingerprint access
is non-functional.
Replace batteries immediately.
Supplied physical backup keys
can be used to unlock the door.
Alternatively, use a 9V battery as
shown below to temporarily
activate the lock.
Hold a 9V alkaline battery against the
contact points located at the bottom
front side of the lock hold to activate
the fingerprint reader and scan a
registered fingerprint to unlock.
Once
unlocked, replace batteries
immediately.
2.6 Low Battery Alert
_
+
9V
Alkaline
battery
To Next Page
Loading...
Need help?
General
