3.5 Checking the Access Codes
SECTION 3.5
While in Programming Mode, select
“3CH” to check registered Access
Codes. If you are not in Programming
Mode, please see Section 3.2 to
enter Programming Mode.
Active Access Codes will then be
displayed on the screen in
sequence from left to right, top to
bottom. In the example shown on
the left, the Access Code
displayed is 1 3 5 7 9 0 .
OK Button
Rotate through the different Access Codes by touching any number on the screen.
To exit Check Access Code screen, simply press the OK Button.
If there are no Access Codes registered in your smart
lock, Check Access Code mode will be invalid. The
default Access Code will not be shown on the display
keypad, and you will see the following screen shown to
the left instead.
15
To Next Page
Loading...
Need help?
General
