Need help?Do you have a question about the Loewe Connect 22 SL and is the answer not in the manual?
General| Response time | 8 ms |
|---|---|
| Display diagonal | 22 \ |
| Display brightness | 250 cd/m² |
| Native aspect ratio | 16:9 |
| Native refresh rate | 50 Hz |
| LED backlighting type | Edge-LED |
| Supported video modes | 1080p |
| Contrast ratio (typical) | 750:1 |
| Display diagonal (metric) | 56 cm |
| Screen format adjustments | 4:3, 16:9, Zoom |
| Supported graphics resolutions | 1920 x 1080 (HD 1080) |
| 3D | No |
| Annual energy consumption | 47 kWh |
| Tuner type | Analog & digital |
| Analog signal format system | NTSC, PAL, SECAM |
| Digital signal format system | DVB-C, DVB-S2, DVB-T |
| RMS rated power | 20 W |
| Number of speakers | 2 |
| DVI port | - |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Digital audio optical out | 1 |
| Audio formats supported | MP3 |
| Image formats supported | JPG |
| Video formats supported | MPEG, MPEG2, MPEG4 |
| Number of OSD languages | 19 |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | - W |
Weight and Dimensions| Depth (without stand) | 44 mm |
|---|---|
| Width (without stand) | 534 mm |
| Height (without stand) | 198 mm |
| Weight (without stand) | 6000 g |
Guidance on handling sensitive components at shielded workstations and using conductive packaging.
Mandatory safety regulations for repair, testing, and operation of electronic devices, including compliance with standards.
Steps to open the TV, including unplugging power, removing leads, and loosening stand screws.
Steps to prepare the Xelos 32 for disassembly, including placing it face down and removing stand screws.
Overview of the MB180 mainboard, its features, and the introduction to its circuit.
Diagnosing issues where the TV works but has no picture or backlight, checking specific pins and components.
Troubleshooting steps for a non-functional CI module, checking supply, control pins, and mechanical insertion.
Diagnosing device failure to boot or hanging in standby mode, indicating potential voltage shorts.
Troubleshooting for non-working LED, IR, or keypad, checking LED card supply and related components.
Troubleshooting USB functionality and no sound problems, checking supply voltages and detection.
Diagnosing issues with device not booting, standby mode hangs, and no signal reception.
Instructions on how to enter and use the service mode via the remote control.
To Next Page