Loewe Speaker 2go - Inbetriebnahme; Laden des Integrierten Akkus; Einschalten; Ausschalten

Speaker 2go - 22 -
Operating instructions
English

Start-up
Charging the built-in battery
The battery in the device is already installed ex factory. Before the first use, the battery must be
charged for about 3 hrs. With a fully charged battery the Speaker 2go is operational for about
8 hrs.
Insert the plug (S) into the socket
12
at the rear side of the Speaker 2go.
Then plug the power adaptor (N) into a 110-240V 50/60Hz mains socket.
The battery charge level is shown by the LED indicator
2
.
LED pulsing red: Device standby, charging battery
LED pulsing white: Device standby, battery fully charged
LED lights up white: Device switched on
Switching on
Set the slide switch
11
to the ON position.
Turn on the Speaker 2go using the key
1
. The LED indicator
2
lights up.
During battery operation the battery capacity level is shown by the LED.
Battery capacity more than 25%: LED lights up white.
Battery capacity 11% to 25%: LED lights up red.
Battery capacity 5% to 10%: LED blinking red.
Battery capacity is below 5%: Speaker 2go switches off (safety buffer).
Switching off
Switch the Speaker 2go to the standby mode using the key
1
.
The LED indicator
2
goes off.
After 10 minutes without audio playback or key operation, the Speaker 2go
automatically switches to standby mode.
When the speaker is not used for a longer time and before a transport, set the
sliding switch
11
to the OFF position.
S
12
1413
11
N
ON/OFF
ON/OFF