LOGICDATA DMP240 User Manual

DYNAMIC MOTION SYSTEM - SYSTEM MANUAL // PAGE 27
9 TROUBLESHOOTING
9.1 POSSIBLE PROBLEMS AND THEIR SOLUTIONS
Problem Possible cause Solution
The table does not
move
The system is not plugged
in
Ensure that the system has been connected to
the Power Hub correctly
The Actuator is not con-
nected properly
Ensure that the Actuator is properly connected
to all components of the system
Poor plug connection Ensure that all plugs have been connected
properly
The Actuator is defective Replace the Actuator. Contact LOGICDATA if the
problem persists
The User Interface is
defective
Replace the User Interface. Contact LOGICDATA
if the problem persists
The table only moves
slowly downwards
There was power failure
while the table was in
motion
Perform a Position Reset Procedure (see Chapter
4.7 Performing a Position Reset Procedure)
The Power Hub was
disconnected while the
device was in motion
Reset required
The Actuator is defective Replace the Actuator. Contact LOGICDATA if the
problem persists
The User Interface does
not work
The User Interface is
defective
Replace the User Interface. Contact LOGICDATA
if the problem persists
For further information, or if you are experiencing problems that are not covered in this chapter, refer to the
Operating Manual of each individual product in the DYNAMIC MOTION system.

LOGICDATA DMP240 Specifications

General

Brand	LOGICDATA
Model	DMP240
Category	Control Systems
Language	English