LOGICDATA SILVERlite - Step 1: Attaching the Legs; Step 2: Preparing the Outer Frame

13ADJUSTABLE BED FRAME - OWNER’S MANUAL //
DO NOT REMOVE STRAPPING TAPE
USE LABELS ON SIDE RAILS
DO NOT REMOVE PROTECTIVE MATERIAL
STEP 2: PREPARING THE OUTER FRAME
WALL
Lay the Crossbars (D) and Side Rails (A,
B) on the ground, as shown in the picture.
IMPORTANT:
• Ensure the Crossbars are parallel
and roughly 5 feet (150 cm) apart.
• Use the labels on the Side Rails to
ensure they are oriented correctly.
• Use the Crossbars to determine
the position of the Side Rails. The
Side Rails should be the width of the
Crossbar apart.
D
B
A
STEP 1: ATTACHING THE LEGS
1. Position the rst Leg (C) below
the Side Rail (A/B) as shown in
the picture.
2. Turn the Leg to screw it into
the Side Rail. It should be hand
tight.
3. Repeat Steps 1 and 2 to Screw
in the other 3 Legs.
A B
C