25ADJUSTABLE BED FRAME - OWNER’S MANUAL //
3. Insert two 9V batteries into the Power Converter. Do not use
rechargeable batteries.
4. Make sure no heavy objects or any person is on the bed or
in the range of moving parts.
5. Press the Button on the Power Converter until the Bed Frame
reaches the at position:
8. TROUBLESHOOTING
BEHAVIOR
Remote lights up but the
Bed Frame does not re-
spond when Buttons are
pressed.
Remote does not light up.
The Bed Frame does not
respond when Buttons are
pressed.
Parts of the Bed Frame re-
main in an elevated posi-
tion after a power failure.
POSSIBLE CAUSE / SOLUTION
1. The Bed Frame is not connected properly. Check the power
connection
2. Time-out has been reached due to continuous operation. Do
not operate the Bed Frame for at least 6 minutes. This will re-
set the time-out.
3.
Unplug the Power Converter. Wait until the LED goes out,
then plug it back in.
Replace the batteries in the Remote Control.
If power cannot be restored, an Emergency Lowering is required.
Proceed as follows:
1. Unplug the Power Converter from the mains
2. Remove the cover of the Power Converter (see below):
To Next Page
Loading...
Need help?
General
