49
Getting Ready
This microwave is designed for home use. It should not be used for commercial catering.
1. After unpacking your microwave, check that it has not been damaged whilst in the box.
Make sure there are no dents, and the door closes properly. A damaged microwave
could allow microwave energy to escape. Make sure that you have taken out all the
packaging from inside the microwave. Please dispose of the plastic wrappings / bags
safely and keep out of the reach of babies and young children.
Underside View
• Remove the turntable plate
and turntable support before
turning the microwave upside
down.
30cm
20cm
20cm
Start/
+30Sec./Conrm
T
i
m
e
r
W
e
i
g
h
t
A
u
t
o
M
e
n
u
Clock/Pre-Set Stop/Clear
Microwave
Weight/
Time Defrost
2. Choose a at work surface for your
microwave away from heat sources such
as radiators or res and away from cold
areas. The surface should be at least
85cm above the oor. Place the back of
the microwave against a wall and allow
a 20cm space on both sides of the unit
and 30cm above so that warm air can
escape from the vents during cooking.
This microwave is not designed to be
built in.
3. Plug your microwave into a standard
household electrical socket (230V~,
13 amp rated). Avoid using a socket
that also has an adaptor and other
equipment plugged in. Do not use a
multi-adaptor.
4. Put the turntable support inside
the microwave and place the glass
turntable plate on top of the support.
The turntable support is shaped
to sit securely on the spindle. You
must always use the turntable plate
and support whenever you use the
microwave.
5. To protect your work surface, we
recommend that you x some non-slip
cushion buttons (not included) to the
underside of the microwave.
L17MSW13E_IB_130506_Shaun.indb 49 06/05/2013 11:23 AM
To Next Page
Loading...
Need help?
General
