Initial Setup
Connecting the Aerial
Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the RF (75Ω) socket on the rear of your TV.
Do not connect the TV to the mains supply
until you have completed all the connections.
RF coaxial cable
(not included)
Turning the TV On for the First Time
Connect the mains cable to the mains socket after you have 1.
completed all the connections.
Switch on the 2. POWER ON/OFF switch at the bottom of the TV.
At this stage, the TV switches to standby mode. The red LED
indicator will illuminate on the front panel of the TV.
In standby mode, press the3.
/ I button on the top panel of the
TV or the
button on the remote control to turn the TV on. The
red LED indicator will turn blue.
Always disconnect the TV from the mains socket when not in
use for a long period of time.
The
/ I button on the top panel of the TV or the button
on the remote control is only used for switching the TV into
standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove
the mains plug from the mains socket or switch off the
POWER ON/OFF switch.
The first time you turn the TV on, it will go straight into the 4. FIRST
TIME INSTALLATION menu.
Press the 5.
buttons to navigate the menu and change the settings.
Country Select the country where you will operate the TV.
Delete Program Select to delete the tuned channels in the TV.
Search Program Perform search automatically for analogue and
digital TV programmes.
Select 6. YES on the screen and press the OK button on the remote
control to start the First Time Installation.
Select NO on the screen to cancel the First Time Installation.
A First Time Installation reminder will appear the next time you
turn on the TV.
To Next Page
Loading...
Need help?
General
