Moving and Installing
Installing the Noise Protection Board
To reduce the noise produced by the washing machine, install the noise protection board.
1. Lay down the machine. Unscrew the four feet.
2. With the felt side of the noise protection board facing the inside of the machine, fit the
board onto the bottom of the machine. The 4 holes in the board should correspond to
the screw holes of the levelling feet.
3. Screw the 4 levelling feet back on to fix the noise protection board to the machine.
4. Stand the machine upright.
Removing the Transit Bolts
Three transit bolts keep the interior of the washing machine in place while it’s being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Fix the Noise Protection Board onto the bottom of the machine BEFORE
removing the transit bolts.
Don’t run the washing machine without removing the transit bolts, as this can
cause excessive vibrations.
Two or more people are required to carry the washing machine and for any
installation work.
Do not lean or push the machine towards its front.
To Next Page
Loading...
Need help?
General
