14
3 Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial
cable to the aerial socket on the wall
and the other end of the cable to the
ANT socket on the back of your TV.
2. Plug the TV into a mains socket and
switch on at the mains.
3. In standby mode, press the
button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
The first time you turn the TV on, it will go straight into the First Time
Installation menu. Most of the settings are pre-set so you can just press OK.
Please ensure the aerial is plugged in.
4. Press the
buttons to highlight your LANGUAGE then press OK.
5. Press the
buttons to highlight your COUNTRY then press OK.
6. Select Home Mode by pressing the OK button.
7. Press the
buttons to highlight your desired picture mode. Its set to Natural
as this is the most energy efficient mode. Then press OK.
Do not connect the TV to the
mains supply until you have
completed all the connections.
HDMI3
HDMI 2
(ARC)
LAN
ANT.
VGA
Optic.OUT
SPDIF
R L VIDEO
RF coaxial cable
(not included)
Logik 65' LED Smart 4K HDR TV L65UE18 Manual.indd 14 25/10/2018 09:40
To Next Page
Loading...
Need help?
General
