8
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Fitting the Feet to the TV
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Keep the protective bag on the TV to protect it.
3. Make sure you have some help, this requires 2 people. Lay the TV down on a flat surface ideally on the edge of a table so the base of the
TV slightly overhangs the edge of the table, with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel
or thick piece of foam) is placed beneath the screen. Be very careful not to knock the edges of the TV, the screen is very fragile.
4. The feet are marked up as Left and Right. They can only be attached with the right foot on the right side of the TV as you look from the back
and the left on the left side. Attach each foot with 3 of the supplied screws.
Table
Right FootLeft Foot
HDMI3
HDMI 2
(ARC)
LAN
ANT.
VGA
Optic.OUT
SPDIF
R L VIDEO
Protective
bag
Cushioned
material
Logik 65' LED Smart 4K HDR TV L65UE18 Manual.indd 8 25/10/2018 09:40
To Next Page
Loading...
Need help?
General
