21
Cleaning the Condenser
Allow the condenser to cool down before removing it.
1. Turn o the dryer and remove the plug
from the mains. Allow the dryer to cool
down.
2. Open the condenser ap on the front
of the dryer.
3. Release the blue clips.
4. Gently pull the condenser out of the
housing.
5. Remove any dust or u from
the condenser, you can rinse the
condenser under a tap to clean
between all the metal ns.
6. Dry the condenser and slide it back
into the housing and close the blue
clips.
7. Close the condenser ap on the front
of the dryer.
Cleaning the Humidity Sensor
If you look inside the drum you will see 2 metal strips. They are at the front of the drum behind
the lint lter. These need cleaning from time to time at least 4 times a year.
• Allow the dryer to cool down. Open the door, you might want to remove the lint lter so you
can access the sensor easier.
• Wipe the sensor with a damp cloth, remove any lint or u is there is any stuck to the sensor.
Do, not use any cleaning products when cleaning the sensor.
Logik Condenser Tumble Dryer LCD7W18 Manual.indd 21Logik Condenser Tumble Dryer LCD7W18 Manual.indd 21 16/09/2021 16:1616/09/2021 16:16
To Next Page
Loading...
Need help?
General
