9
5. Install one end of the drain hose at the back of the machine. Fit with the clamp and
tightened with a screwdriver. Fix and secure the other end of the drain hose into a sink or
bucket with the suction cup.
• Do not bend your drain hose.
• Do not lift the drain hose higher than 10 cm from the table top, otherwise the unit
may not be able to expel the waste water properly.
• Ensure the water inlet and drain hoses are not kinked or squashed. The unit must
not stand on the mains cable.
• The electrical connection conditions must correspond with the specications on
the rating plate of the dishwasher. Do not use extension cables.
or
LDW2PB20N_IB_5L_Final230130.indb 9LDW2PB20N_IB_5L_Final230130.indb 9 30/1/2023 2:41 PM30/1/2023 2:41 PM
To Next Page
Loading...
