14
Adding Salt
If the water in your area is hard, deposits will form on your dishes and utensils. As such, this
appliance contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and to correspond to the
water hardness level in your area.
1. Remove the basket and unscrew the reservoir cap.
2. Place the funnel provided over the salt reservoir. Pour in
approximately 1.2kg of dishwasher salt depending on
the brand used.
3. Fill the reservoir with water until it overows (rst use
only).
4. Clean any excess salt from around the reservoir opening
and then screw the cap on again rmly.
5. Run the P3 wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt
from the compartment.
open
open
open
• The salt rell warning indicator on the control panel will illuminate when the
reservoir is running out of salt and requires relling.
• The salt rell warning indicator will cease to illuminate within a few days, depending
on how quickly the salt dissolves.
• If you decide to use a detergent tablet, you may not need to add salt, this depends
upon the water hardness in your area and the type of tablet being used. Check with
your water supplier and the detergent tablet manufacturers instructions.
LDW2PB20N_IB_5L_Final230130.indb 14LDW2PB20N_IB_5L_Final230130.indb 14 30/1/2023 2:41 PM30/1/2023 2:41 PM
To Next Page
Loading...
