Logik LDW2PB20N - Starting a Wash Cycle; Changing a Programme; At the End of a Programme; Switching off the Unit

19
GB
If the dishwasher is not going to be used for a long period of time, e.g. whilst on
holiday, disconnect the unit from the mains supply and turn o the water supply.
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water
pressure between 0.04MPa and 1.00MPa), or if not connected to the water supply, ensure the
dishwasher tank is full of water.
2. Open the door. Pull out the dishwasher basket, load the dishes and push the basket back.
3. Pour in the detergent or place the detergent tablet.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly.
Do not slam the door.
5. Press the
button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to
the section Wash Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. Press the
button, the washing cycle will begin shortly.
Changing a Programme
You can change the washing programme if it has just started for a short time.
Press the
button to pause the washing. Then press and hold P until the unit becomes standby
state. Press P again to select the new programme and conrm the selection by pressing the
button. The unit will start the new washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
Switching O the Unit
To save energy, remember to switch the dishwasher o using the button. The dishwasher will
continue to use electricity unless it is switched o with the button. Turn o the water supply.
If you open the dishwasher’s door during the washing cycle and then close it, the
dishwasher will continue the current washing programme after 10 seconds.
You can add dishes to wash after the washing programme has begun for a short time.
Press the
button to pause the washing. Open the door, add the dishes then close the
door. Press the button to resume the washing.
Save energy
• Manual pre-rinsing of items leads to increased water and energy consumption and is
not recommended.
• Washing tableware in a household dishwasher usually consumes less energy and
water than hand dishwashing provided the household dishwasher is used according
to the manufacturer’s instructions.
LDW2PB20N_IB_5L_Final230130.indb 19LDW2PB20N_IB_5L_Final230130.indb 19 30/1/2023 2:41 PM30/1/2023 2:41 PM