8
1. Ensure there is clearance each side of the
unit to allow slight sideways movement for
servicing when required. Do not block the
ventilation outlet on the right side of the
unit.
2. Do not connect the unit to the mains socket
before installation. Ensure you are not
installing the unit right in front of the mains
socket. This is to avoid potential damage to
the back of the unit.
After installing the appliance, ensure that
the mains plug is easily accessible.
3. Position the unit next to a water tap and a
drain.
Location
When selecting a position for your dishwasher you should make sure the installation surface
is at and rm, and the room is well ventilated. Avoid locating your dishwasher near a heat
source, e.g. cooker, boiler or radiator. Extreme cold ambient temperatures may also cause
the appliance to not perform properly. This dishwasher is not designed for use in a garage or
outdoor installation.
Do not drape the dishwasher with any covering. When installing, ensure that free space is left
at the sides.
4. This unit MUST BE connected to COLD
WATER MAINS using the new water inlet
hose. OLD HOSE SETS MUST NOT BE
RE-USED. The water pressure from the
water mains needs to be at a minimum of
0.04 MPa and a maximum of 1.00MPa.
Alternatively, you can also pour cold water
into the dishwasher tank manually. Turn on
the dishwasher rst. Open the cap on top of
the unit and pour water into it.
• If there is not enough water in the tank,
will light up.
• If the dishwasher tank is full, the unit will
beep.
Installation
or
All parts removed must be saved to do the reinstallation in the future. Ensure the
dishwasher is unplugged and empty. We recommend that 2 people handle the
dishwasher during installation.
LDW2PB20N_IB_5L_Final230130.indb 8LDW2PB20N_IB_5L_Final230130.indb 8 30/1/2023 2:41 PM30/1/2023 2:41 PM
To Next Page
Loading...
