21
Burner parts Replacing the burner parts
The surface of the burner cover will gradually lose its gloss finish with time. This is quite normal and will not
effect the efficiency of the hob.
Replacing the Burners
Check that:
• The ignitor is always clean to ensure trouble-free sparking.
• The FSD probe is always clean to ensure correct operation of the safety valves.
Hob Controls
If you have problems with the hob controls (gas taps), call your Authorised Service Centre.
These parts are not user serviceable.
Burner Parts and Pan Supports
You can remove and clean these parts with hot soapy water or non-abrasive detergents. Clean spills regularly
before they become burnt on. Do not wash these parts in a dishwasher.
After cleaning, check that the burner rings and burner caps are dry before replacing correctly.
It is very important to check that the burner rings and burner caps have been correctly positioned.
Failure to do so can cause serious problems.
To avoid damage to the ignition circuit NEVER light the hob when the burners are not in place.
• Both the ignitor and probe must be very carefully cleaned using a toothbrush.
• When replacing the burner parts, ensure you do not damage the ignitor or temperature probes.
* All images are for indication only; please refer to your individual unit for actual item.
LFTG90W14_IB.indd 21 09/02/2015 17:51
To Next Page
Loading...
Need help?
General