22
Cleaning the Filter Net of the Water Supply Hose
1. Turn o the power. Turn the water supply o at the tap.
2. Remove the water supply hose from the tap.
3. Manually remove the lter net located on the tap side of the water supply hose and clean
using a small brush (e.g. a toothbrush).
4. Return the lter net to its original position.
5. Re-connect the water supply hose to the tap and turn the tap back on, checking for leaks.
Before cleaning the drain lter, switch o and unplug the washing machine.
1. Carefully loosen the drain lter. Water may drain out - this is normal.
2. Unscrew the lter to remove it.
3. Remove any lint and debris before carefully replacing the lter.
4. Turn the lter to screw back into place.
about
50°C
Cleaning the Drain Filter
Preventing a Frozen Water Supply Hose
If your washing machine is delivered in freezing weather conditions,
leave it at room temperature for 24 hours after you’ve set it up before
using it. This ensures there’s no ice blocking the water supply hose. If
your water supply hose freezes, add 2 or 3 litres of warm water to the
drum. Then run a “Rinse & Spin” programme.
about
50°C
Be careful not to burn yourself while cleaning the drain lter. Water draining from
the lter compartment may be hot after a high temperature wash.
LIW714W20_IB_Final200729.indd 22LIW714W20_IB_Final200729.indd 22 29/7/2020 5:33 PM29/7/2020 5:33 PM
To Next Page
Loading...
