12
8. Screw the levelling feet x board, bottom
hinge and levelling feet tightly on their
new position.
9. Remove the middle hinge hole covers and
swap their position with the middle hinge.
Reverse the middle hinge.
6. Remove both levelling feet, levelling feet
x board and bottom hinge. Swap the
position of the levelling feet x board with
the bottom hinge.
7. On the bottom hinge, move the position
of the bottom hinge pin to the other hole.
Tighten the pin securely.
• Do not lay the unit at as this
may damage the coolant system.
• During door reversal, when
swapping the position of the
bottom hinge or adjusting the
levelling feet, tilt the unit. Do not
lay the unit at.
LNFD55W_X_T18_IB_RC_190410_grace.indd 12 10/4/2019 7:50 PM
To Next Page
Loading...
Need help?
General
