Engine Storage
- 15 -
8. Engine storage
After the engine stalling, do not clean the engine till it cools for over half an hour. Clean all
surfaces of the engine and mend the damaged paint film, apply antirust oil on the rusting
area.
Do not rinse the engine with high pressure water, because the water may enter the air
cleaner and the muffler, even enter the cylinder along the inlet line, thus rust may occur.
Do not clean the engine till it is cool, because the water splashed on the hot engine is
harmful to the engine.
1) Place a container under the carburetor (under overflow pipe).
2) Unscrew the draining screw of the carburetor， drain the fuel in the carburetor from the
overflow pipe to the container. After finishing that, tighten the draining screw.
3) When using the engine again, replace oil.
4) Remove two spark plugs.
5) Fill 5lm-10lm oil in the head.
6) Rotate the engine in several turns to
7) scatter the oil in the head.
8) Reinstall the spark plug.
9) Rotate the engine slowly till a drag is felt. In such case, all valves are closed to prevent
the humidity from air.
10) Cover the engine with a dust cap, and place it in dry and ventilating area.
11) In storage，the battery is charged every one month, it will prolong the service life of
the battery.
Caution
To Next Page
Loading...
Need help?
General
