93
Changing the coolant
The coolant must be changed by a BMS dealer
at the intervals specified in the periodic
maintenance and lubrication chart. Adding
water instead of coolant lowers the antifreeze
content of the coolant. If water is used instead
of coolant, have a BMS dealer check the anti-
freeze content of the coolant as soon as possi-
ble.
The radiator fan is automatically switched on or
off according to the coolant temperature in the
radiator.
Mix antifreeze with distilled water only.
However, if distilled water is not available, soft
water may be used for refilling.
If your vehicle overheats, see Chapter 8 for in-
structions.
Axle boots
Check the axle boots for holes or tears. If any
damage is found, have them replaced by a BMS
dealer.
1. Front Axle Boots (×2 each side)
2. Rear Axle Boot (×2 each side)
To Next Page
Loading...
Need help?
General
