Do not touch the glass
part of the headlight bulb to keep it free
from oil, otherwise the transparency of
the glass, the luminosity of the bulb, and
the bulb life will be adversely affected.
Thoroughly clean off any dirt and finger-
prints on the headlight bulb using a cloth
moistened with alcohol or thinner.
6. Reinstall the bulb holder by pushing it in
and turning it clockwise.
7. Reinstall the cover at the rear of the head-
light.
8. Close the hood.
Tail/brake light bulb replacement
If a tail/brake light bulb burns out, replace it as
follows:
1. Remove the quick fastener screws, nuts
and bolts from panel A (if replacing the
left tail/brake light bulb) or panel B (if re-
placing the right tail/brake light bulb).
2. Lift the cargo bed up.
3. Remove the panel (panel A or B).
4. Remove the tail/brake light bulb holder
(together with the bulb) by turning it
counterclockwise.
5. Push the burnt-out bulb in and turn it
counterclockwise to remove it from the
bulb holder.
6. Push a new bulb in and turn it clockwise to
install in the bulb holder.
7. Reinstall the bulb holder (together with
the bulb) by turning it clockwise.
8. Install the panel.
To Next Page
Loading...
Need help?
General
