Long range MT4300 - System Setup Options; Mode and Clock Settings; Target Management Settings

4
5
6
7
Chg Mode
ere is where you set the MT4300 to Tournament or Target TAG Mode. Tournament Mode
does not require the card system to operate. Target TAG Mode requires users to have a valid
card to launch targets with the MT4300 or to preload targets onto the unit. Target TAG is
discussed in detail in another section 29. The Power Down option allows users to set the
amount of inactivity before turning o󰀨. The 3 options are 15 minutes, 1 hour, or 2 hours.
Set Clock
This is only used for the Target TAG counter system. se your keypad to enter the time and
date. se NTR to move to the next number.
Back light
The screen on the MT4300 has a back light which is useful for low lighting and night shooting.
With this option, you can turn it ON or O󰀨 or choose how long the back light stays on after a
period of inactivity.
Target Mgt
This menu is used in conunction with the Target TAG counter system and has two options:
Target Margin and Set Tier Price.
Target Margin is used to set the number of targets given for No Birds and broken birds. This
number is automatically added to the Target Bank when targets are added using 5 Stand Cards
33. Set the Target Margin from ero to 40. Press NTR.
Set Tier Price is used in conunction with cash cards and allows you to set the price per
target for di󰀨erent customers depending on membership status and other attributes. For more
information on setting tier price, see the section on Cash Cards 33.
25
3
Trap Status
iagnostic tests for Long Range LLC use only.
The message format may be set to 3 or 4 byte. The default message format is 4 byte. To change this,
from the Chg System ID Menu, press 2 to select Msg Format. Press the 1 button for 3 byte, or press
the 2 button for 4 byte. Press BAC to save.
1
2
Set System I Ds
RF Channel
Msg Format
1
2
Message Length
3 Byte
4 Byte
It is now possible to set the channel/frequency and trap number on the R4300 Receiver without using
dip switches. This is done with Link Mode which is found in the Set RF Channel Menu. This process
is discussed in detail on the following page 26.
Box ID is also changed here. Box ID is used to identify the MT4300 when used with the Target TAG
counter system.