Look Solutions Viper NT - Operating the Viper nt; Putting into Operation and Switching Off

9
5. Operating the Viper nt
The Viper nt is a powerful fog generator, producing every desired effect from a
tiny puff of smoke to the thickest fog.
Digital technology makes fine adjustments of the pump possible. In steps of
1% the output can be adjusted from 1-99%.
5.2 Putting into operation
a. Connect to the mains supply. Make sure the correct voltage is selected (120 V/
60 Hz). A „P” and two figures appear on the display.
b. After a warm up time of approx. seven minutes the Viper nt is ready to start.
The green Ready-Led [20] blinks if the working temperature is reached. As
soon as the final temperature is reached, the LED lights solid.
c. Adjust the required output via the control panel and press the Enter-button
[16] once to start the fogging process. Press the Enter-button again to stop the
fog (see point 5.4).
P25
a. Press the Mode-button [14] til „OFF” appears on the display. After 15 seconds
the machine will switch off automatically. On the right bottom edge of the
display a red decimal point appear.
You can also switch off the machine within these 15 seconds by pressing the
Enter-button [16].
b. When you switch off the DMX signal, the machine will be switched off
automatically after 15 seconds.
.
5.3 Switching the device off