Lopi Deerfield - Installation

Installation (For Qualified Installers Only) 7
© Travis Industries 12/18/20 - 1550 Deerfield Stove
Heating Specifications
Approximate Maximum Heating Capacity (in square feet)* ............................................ Up to 2,500 Sq. Feet
BTUs Per Hour ............................................................................................................... 13,940 to 49,200**
BTUs Per Hour (net output) ........................................................................................... 10,916 to 35,777**
Burn Rate (Pounds per Hour)*** .................................................................................... 1.7 to 6
Maximum Burn Time on Low Burn*** ............................................................................. 35 Hours
Hopper Capacity ............................................................................................................ 60 Pounds
Turn-Down Ratio ............................................................................................................ 67%
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside temperature. It is
also affected by the fuel size, quality, and moisture level.
** Based on 8,200 BTUs. per pound input
*** Small pellet size will decrease the stated burn rates and burn times. Differences of plus or minus 20% depending on
fuel quality may occur.
Dimensions
Electrical Specifications
Electrical Rating ...................................................................................................... 115 Volts, 4 Amps, 60 Hz
Watts during Start-Up Sequence ............................................................................ 480 (approximately)
Watts during Operation ........................................................................................... 300 (approximately)
Fuel
This heater is designed and approved for pelletized wood fuel only (all grades). Travis Industries Inc.
recommends using only fuel that is certified by the Pellet Fuels Institute (PFI).
Emissions
This heater meets the 2020 U.S. EPA’s emission limits for pellet heaters. Report# 0028PS107E.REV001
Tested to ASTM E2779-10, ASTM2515, CSAB415.1-10 This heater has been shown to deliver heat at
input rates ranging from 10,916 to 35,777 BTU/hr. net output, and emission value of 1.23g/h.
Efficiency
This model was tested for efficiency using method B415.1-10 and was determined to have a weighted
average Higher heating value (HHV) Overall Heating Efficiency (OHE) of 77%.