What causes arc or short circuit between contact tip and gas nozzle in LORCH M 2020?
An arc or short circuit between the contact tip and gas nozzle in your LORCH Welding System can be caused by spatter build-up inside the gas nozzle. Remove it with special pliers.
What causes higher wire wear out at wire-feeding unit of LORCH M 2020?
Higher wire wear out at the wire-feeding unit of your LORCH Welding System can occur if the wire rolls do not fit the wire diameter. Install the correct wire rolls. It can also be caused by incorrect contact pressure at wire feeding; adjust as described in the manual.
What to do if there is not sufficient shielded gas in my LORCH M 2020 Welding System?
If there is not sufficient shielded gas in your LORCH Welding System, it could be due to: * Wrong adjusted quantity of shielded gas: Adjust it correctly as described in the manual. * Dirty pressure reducer: Check the valve. * Torch, gas hose blocked or not airtight: Check and replace if necessary. * Shielded gas being blown away by draught: Avoid draught.
What to do if mains control lamp 40 does not light on LORCH M 2020 Welding System?
If the mains control lamp 40 does not light on your LORCH Welding System, it means that a phase is missing in the mains. Check the machine at another socket and check mains and fuses.
What to do if the fan of my LORCH M 2020 Welding System is not working?
If the fan of your LORCH Welding System is not functioning, it indicates a missing phase in the mains. Check the machine at another socket and check the mains and fuses.
Essential safety rules for operating welding and cutting machines to prevent injuries.
Guidelines for safe transportation of welding equipment, including lifting and securing.
Instructions for connecting the torch to the central socket of the welding machine.
Guidance on plugging the unit into the mains socket with appropriate fusing.
Steps for opening the machine lid and mounting the wire spool on the pick-up.
Procedure for inserting the wire electrode into the torch, including contact tip removal.
Instructions for connecting the ground cable to the machine and workpiece.
Ensuring proper connection of the ground clamp to the welding location.
Explanation of the main switch, mode selector, step switch, and control knobs.
General| Brand | LORCH |
|---|---|
| Model | M 2020 |
| Category | Welding System |
| Language | English |
To Next Page