110
Client Software for PC or Mac
Modifying an NVR
1 Click the NVR you would like to modify and click Modify.
Click the NVR
Click Modify
2 Change the connection info as needed and click Modify.
Deleting an NVR
• Click the NVR you would like to delete and click Delete. Click Yes to confirm.
Click the NVR
Click Delete
Configuring an NVR Through Device Management
You can configure your NVRs settings through the client software.
To configure NVR settings:
• From the Control Panel, click
.
• Click the NVR you would like to configure and click Remote
Configuration. See below for
details on available settings.
Click the NVR
Click Remote Configuration
Information
The Information sub-menu shows system information about the NVR.
To Next Page
Loading...
