129
Client Software for PC or Mac
5 Under Warning, check to enable the following warnings when the Video Loss Alarm is
triggered:
• F
ull Screen Monitoring: The sel
ected channel will open in full screen.
• Audible Warning: Sys
tem will beep.
• Notify Surveillanc
e Center: An alert will be sent to the client software.
• Send Email: A
n alert email will be sent. Note that you must set up email alerts.
6 Click Sav
e to save changes.
PTZ Control (Not Supported)
Network Connection (Not Supported)
System Configuration
The System Configuration menu allows you to configure settings for the Client Software.
To access System Configuration:
• From the Control Panel, click Sys
t
em Configuration ( ).
General
To configure General client options:
1 Configure the following:
• Interval of Screen Switching: Sel
ect the time channels will be shown in Main View before
switching when Sequence mode is on.
• Log Keeping Time: Sel
ect the amount of time the client software will retain system logs.
• View Scale: Sel
ect the aspect ratio for your cameras: Full-screen (may cause image
stretching), 4:3, or 16:9.
• Network Performance: Sel
ect Low, Middle, or High.
• CPU Performance: Sel
ect Low, Middle, or High.
To Next Page
Loading...
Need help?
General