Using the System
7
8. Overwrite icon: Indicates Overwrite mode is on, which means the system will over-
write the oldest recordings when the memory card is full. For details, see 9.6 Enabling
/ Disabling File Overwrite, page 28.
9. File icon: Indicates that there are new recordings saved to the SD card.
10. Battery indicator: Shows remaining battery life. Icon turns red when battery is crit-
ically low to indicate that the receiver should be plugged into a local power outlet right
away.
11. Time stamp: The current date and time on the system.
12. Motion recording icon: Indicates that motion recording is turned on.
13. Volume indicator: Shows the current volume of the receiver. You must be in single-
channel viewing mode to change volume.
14. Download icon: Indicates that a new firmware is available in the server to download.
7.2 Navigating Menu Screen
Use the system menus to configure settings.
• Press to open the Main Menu.
• Use the joystick to move the cursor left, right, up, and down.
• Push the joystick to open sub-menus and confirm / save menu selections.
• Press
to exit menus without saving changes.
7.3 Viewing Modes
There are four different viewing modes available on the system: single channel viewing,
Auto Sequence Viewing mode (view individual channels automatically in sequence), Quad
mode, and Scan mode (for details, see 11 Scan Mode, page 33).
To change viewing modes:
• Press
to select between Quad mode (half-Quad mode when only 2 cameras are
connected) and Auto Sequence viewing mode.
OR
• Press
to switch between channels 1~4 in single channel view.
NOTE
Depending on the number of cameras packaged with the system, half-Quad mode (2 cameras) or single
channel viewing (1 camera) is enabled when you first power on the system.
#LX400077; r.35258/35258; en-US
16
To Next Page
Loading...
