Scan Mode
11
In Scan mode, the receiver’s LCD screen and speaker will turn off unless motion is de-
tected by one of the cameras. The LCD screen turns on and displays video from the cam-
era where motion was detected for 15 seconds before turning off again.
You can configure how much motion is needed to turn the display on in Scan mode by
changing a camera’s video motion detection settings. See 9.4.3 Configuring Video Motion
Detection, page 27.
To enable Scan mode:
1. Enter live viewing mode.
2. Press
on the front panel of the receiver.
3. Press
again to exit Scan mode.
NOTE
When exiting Scan mode, the receiver resumes live viewing in Auto Sequence Viewing mode.
#LX400077; r.35258/35258; en-US
33
To Next Page
Loading...
