134
Configuring the system remotely
Display menu
To configure channel display settings:
1 Cl
ick the REMOTE CONFIG tab.
2 Co
nfigure the following:
• Channel: Sel
ect the channel that you want to apply the settings to.
• Channel Name: Enter the desired channel name.
• Position: Select the position of where the text appears in the channel.
• U-L: Upper left hand corner
• D-L: Lower right hand corner
• U-R: Upper right hand corner
• D-R Lower right hand corner
• Cov
ert: Select Enable to blank out the channel locally on the DVR. Note that the system will
continue to record despite being in Covert mode.
• Display Record Time: Show or hide the channel recording time.
3 In
the selection boxes, select the channels that you wish to apply the settings to.
4 Cl
ick Save to apply your settings.
To Next Page
Loading...
