15
Starting the System
Starting the System
To power the system ON:
• 4/8 Ch
annel: Connect the power cable to the DC 12V port on the rear panel.
• 16- Channel : Press I on the power switch on the rear panel of the system.
At startup, the system performs a basic system check and runs an initial loading sequence.
After a few
moments, the system loads a live display view.
To power the system OFF:
• 4/8 Channel: Unplug the power cord from the rear panel of the system. Unplug the power cord.
• 16 Channel: Press O on the power switch on the rear panel of the system. Unplug the power
cord.
Password
ATTENTION: By default, passwords are disabled on the system. You do not need to
enter a password when accessing any system menus. For security purposes, it is
highly recommended to enable passwords on the system using the Password Menu.
For details, see “Managing Passwords” on page 29.
Password menu
To Next Page
Loading...
