ISSUE NO. V1.3 DATE 12/12/00 11
To choose the port for the measurement log select
[PORT]
.
Select port for measurement log
Parallel Serial Both
^ ^ ^ ^
Parallel: The measurement log is sent to the parallel port.
Serial: The measurement log is sent to the serial port in ASCII format.
Both: The measurement log is sent to the parallel port and then to the serial port.
User and sample ID options
When User ID:ON is selected, the user is asked to enter an ID number each time a measurement is made. This number can be up to 4
numeric characters long. When Sample ID:ON is selected, the user is asked to enter the ID number of the sample each time a
measurement is made. This number can be up to 10 numeric characters long.
Press
[Menu]
Select menu option
Scale Options Interfaces
^ ^ ^ ^
Select
[Options]
Select menu item
Meas ID Params Logging Menu
^ ^ ^ ^
Select
[Meas ID]
User ID:ON Sample ID:ON
Off Off Apply
^ ^ ^ ^
The User ID function can be toggled on and off by pressing the
[ ^ ]
directly below it. The Sample ID function can be toggled on and off
by selecting the
[ ^ ]
directly below it.
When the required settings have been made, select
[Apply]
to exit from this menu.
Menu access
This function is designed so that the menu system can only be accessed by means of a password.
Press
[MENU]
Select menu item
Scale Options Interfaces
^ ^ ^ ^
Select
[Options]
Select menu item
Meas ID Params Logging Menu
^ ^ ^ ^
Select
[Menu
]
Select menu access
Full Password
^ ^ ^ ^
Select
[Password]
. The following will appear:
Enter password Backspace
^ ^ ^ ^
Enter a password using the numeric keypad.
[Backspace]
can be used to delete mis-typed characters. Press the
[Enter password]
to
enter the password.
To remove password protection, press
[Full]
under
Select menu access
.
Note:
With the instrument set to menu access by means of a password, this password must be entered correctly otherwise menu
access is denied. If the password is not recalled then contact Tintometer Ltd for special instructions.
To Next Page
Loading...
Need help?
General
