To Next Page

To Previous Page

Getting started

CG-6 Operation Manual p/n 115370001 Rev A

2—8

Figure 2-9 The CG-6 Autograv

and batteries

If the batteries are in place when the external power supply is connected, the power

supply will power the unit and also charge the batteries if necessary. When the batteries

are fully charged the supply powers the unit so that the batteries maintain their full

charge. The batteries are charged at the same time and take approximately 4 hours to

charge.

Note: When the CG-6 Autograv

is powered by two batteries, then

both batteries will be solicited and will thus discharge in an equal manner.

Charging the CG-6 Autograv

batteries

The CG-6 Autograv

batteries are charged with the Smart Battery Charger (p/n

0221020):

Figure 2-10 The CG-6 Autograv

Gravity Meter and the battery charger

Questions and Answers:

Need help?

Do you have a question about the LRS SCINTREX AUTOGRAV CG-6 and is the answer not in the manual?

LRS SCINTREX AUTOGRAV CG-6 Specifications

General