Chapter 8. Communication Functions
8-57
3) Setting slave station
and program
(1) Create a new project file and new program.
(2) Set for slave station no.1
(3) Create a new project file and make a new program for the slave station.
• Click the list after set the communication method and communication channel.
• Set the parameters according to the following table, and click ‘OK’.
Communication Method Protocol and Mode
Station
No.
Baud
Rate
Data Bit Parity Bit
Stop
Bit
Communication Channel User Defined
1 9600 8
None
1
RS-232C null modem or
RS-422/485
Slave
To Next Page
Loading...
