Chapter 4. Names of Parts
4 -2
No. Name Descriptions
②
I/O LED
Indicates the operating status of I/O
③
Built-in RS-485 connector A connector for built-in RS-485 communications
④
Mode selection key switch
Designates the main unit’s operation mode
y RUN: runs the operation
y STOP: stops the operation
y PAU / REM: the usage of each modules is as follow
- PAUSE: temporarily stops the operation
- REMOTE: remote driving
⑤
Dip-switch for Cnet I/F See Chapter 5. Power Supply / CPU
⑥
RS-232C connector A connector to connect with PADT (GMWIN)
⑦
Expansion connector cover A cover of connector which is used to connect with expansion unit
⑧
Terminal block cover A protective cover for the terminal block’s wiring
⑨
DIN rail hook A hook for DIN rail mounting
4.1.1 60-point main unit
1) G7M-DR60U
To Next Page
Loading...
