SAFETY DECALS
Safety Decal Loacations
Care of Safety Decals.
1. Keep safety decals clean and free of obstructing material.
2. Clean safety decals with soap and water and dry with a soft cloth.
3. If a component with a safety decal(s) affixed is replaced with a new
part, make sure new safety decal(s) are attached in the same location(s)
as the replaced components.
4. Mount new safety decals by applying on a clean dry surface and
pressing air bubbles to outside edges.
Important: Warning decals are visible when getting on backhoe. Refer to the left and right hands
used in this manual, It's the position of the operator when seated in the operating position of
Backhoe
Warning 3102E-00004
Location : Mainframe
Warning 3102E-00005
Location : Both of mainframe sides
Warning 3102E-00006
Location : Both leg cylinders
Warning 3102E-00007
Location : Both side of Mainframe
- 7 -
To Next Page
Loading...
Need help?
General
