5 -21
Hydraulic
oil filter
Open
Close
(2) Replacing Hydraulic Oil Filter
① Hydraulic oil filter (Main)
z Park tractor on level surface and apply parking
brake and lower implements and stop the engine.
z Carefully clean around the filter and set a clean
container under the filter.
z Coat clean hydraulic oil on the packing of new
filter and check the packing is placed well in the
groove.
z Replace the HST filter according to the same
procedure of the hydraulic oil filter.
② HST filter
▶ Be sure to stop the engine before loosening the oil filter.
▶ If the filter or oil is very hot, it may cause serious burns. After cooling down the
tractor sufficiently, replace the filters
.
Warning
z Turn the oil filter CCW to remove with filter
wrench.
z Turn the new filter CW to assemble until the
packing makes contact with the mounting surface.
Tighten CW from ¾ to 1 turn more after packing
contact.
z Run the engine at idle and check any leakage.
z Check the oil level. If necessary, add new oil.
HST filter
Open
Close
To Next Page
Loading...
