3 -8
22
21
22
DPF regeneration indicator
23
DPF temperature indicator
z If the soot loaded is over 60% and the DPF temperature is over the designated temperature, the
regeneration shall start automatically and this indicator shall be ON. But if in INHIBITED mode, this
indicator shall not be turned on. (For further information, see page 3-16)
z When the regeneration of the DPF is being
processed, this indicator shall be ON with
continuous light or blink in various period
according to the soot loaded in the DPF.
(For further information, see page 3-15)
z Depending on the soot’s rate, engine warning
indicator may blink together.
(For further information, see page 3-15)
z If the engine has been shut down, due to heavy
soot’s rate, contact your authorized dealer
immediately. If restarting engine, the engine can
be run for 30 seconds to escape the emergency
state.
24
23
24
DPF inhibited indicator
z When the DPF switch is pressed to INHIBITED mode, this indicator shall be ON and the
regeneration of the DPF shall be halted. (See page 3-17)
Engine warning indicator
To Next Page
Loading...
Need help?
General
