3 -16
⑥ Inhibited regeneration mode operation
NOTICE : Only use this mode when regeneration
needs to be delayed or stopped because of an
operation condition that may risk a fire hazard due
to high exhaust temperatures during regeneration.
NOTE : When the DPF regeneration indicator
light (1) and engine warning light (2) are blinking
during the regeneration process, the inhibited
regeneration mode cannot be set.
The regeneration mode can be delayed or
stopped by the use of the (DPF) switch (3) that is
located on the right-hand side of the dash.
To set the inhibited regeneration mode :
1. Press the lower side (A) of the (DPF) switch (3)
for approximately two seconds.
2. When inhibited mode is activated the (DPF)
inhibited indicator light (4) will be illuminated.
NOTICE : When tractor arrives at a safe
regeneration location, press the upper side (B) of
the (PDF) switch for approximately two seconds
to return the regeneration system to the auto
regeneration mode.
If regeneration system is not returned to auto
mode, excessive soot in the (PDF) may overload
the emission system and result in a reduction of
engine power.
NOTICE : If, when notified by the instrument panel
(DPF) indicator lights that a regeneration of the
(DPF) is needed and the operator does not
proceed with a regeneration of the (DPF), the
functionality of the (DPF) will be impaired.
If the operator continues to ignore or interrupt the
regeneration notification, the (DPF) may become
damaged to such an extent as to require the
(DPF) to be replaced by an authorized LS tractor
dealer.
1
2
B
A
3
4
A:
B:
To Next Page
Loading...
Need help?
General
