4 -2
HST type
Caution
▶Check each part before starting
engine.
▶Check if there is some other
people around before starting.
▶Place all the levers and switches in
NEUTRAL or OFF position.
Brake pedals
HST reverse pedal
Throttle lever
HST forward pedal
PTO switch
Key switch
3. Push throttle lever to
the middle position of
the full throttle.
1. Sit in driver’s
seat and apply
parking brake
2. Place the range gear shift lever
and HST forward/reverse pedal in
NEUTRAL, and PTO switch in OFF.
5. Wait until the cold start
aid indicator is OFF.
(about 10 seconds)
4. Turn key switch to ON
and check if the battery
charging indicator and
cold start aid indicator
are ON.
6. Turn key switch to
START position. As
soon as the engine
starts, release the key
switch to ON position.
8. Run engine for a few
minutes to allow engine oil
and transmission oil to
warm up.
7. Check if the battery
charging indicator and
engine oil pressure
indicator are OFF.
If not, stop the engine
immediately and check the
problem.
Parking brake lever
To Next Page
Loading...
